side dot rod 2x200mm white
Measure the positions and mark with a pointer.
Carefully drill a 2mm diameter hole to a depth of 1.5-2mm.
I like to do this with a hand drill as it goes quick enough and I can keep control.
Glue is not really necessary, but you can put a tiny bit of UHU Allplast on the bottom of the rod.
Push the rod in place and carefully cut the excess with a sharp knife.
Sand the remaining access when all the side dots have been placed.
Good to know!
At Guitar Goods we do our very best to make things as easy and fun as possible, for example: