Sanding drum set for drill
Ideally used on a standing drill.
Determine which diameter you require.
Place the sanding drum on the adapter and tighten.
Place the 6mm pin in your drill and turn the power on.
Support your guitar or headstock in the required angle and move in the opposite direction of the spinning cylinder.
The amount of pressure applied, determines the amount of materials that is removed.
Never hold the wood on one place too long or due to the built-up friction, you will get burn marks.
The cylinders are 80 grit and the set contains 4 pieces of the following sizes (dxh): 15x13mm, 22x25mm, 30x25mm, 40x40mm, 50x40mm.
Good to know!
At Guitar Goods we do our very best to make things as easy and fun as possible, for example: